Hallo,

Misschien heb ik er overheen gekeken in de gebruiksaanwijzing van de Sniper V2 uitlijnlaser vandaar mijn vraag.

1 blokje op het uitlijnraster met hoeveel mm komt dat overeen?

Alvast erg bedankt!

En ja ik moet me ook nog voorstellen en zal dat binnenkort zeker doen met foto's van mijn zoontjes Dino Hero Micromax kart.

Gegroet!
Martin

2mm uit mijn hoofd!

En nog even voor je opgezocht:

The Sniper unit works by essentially re-creating the axis through the two front wheels. The laser in each unit is hand
calibrated to be perfectly parallel to each stub axle. The reference axis formed by the laser beam is then projected on
to a visual grid system to measure camber and toe simultaneously. Each horizontal line (the camber plane) on the grid
is equal to 2mm camber per side. Similarly, each vertical line (the toe plane) is equal to 2mm toe per side. We have
included a dot in the middle of each line as a visual aid to represent 1mm. Therefore, a movement of one full grid
position on the camber plane on each side of the kart would give you what is commonly referred to as “4mm camber”.
A movement of one full grid on the toe plane each side of the kart would equate to “4mm toe”. To keep your front end
geometry symmetrical, both units should have the same toe and camber reading on each side where possible.

Top dank je wel!!!